What is this?
You may change the LumiNode assigned to a job in the middle of data collection. Follow the steps below to assign a different LumiNode for an active job.
⚠️ Peform the following before you begin
- Make sure the replacement LumiNode has sufficient battery charge
- Make sure the original LumiNode has sent all un-transmitted data stored in memory. You may do this by performing a power reset - see instructions here
Video Tutorial
Steps
- Locate your job of interest.
- Check the last updated time and reboot the LumiNode to get the latest data.
- Select the job of interest and tap DETAILS on the top right.
- Tap EDIT on the top right.
- Now, tap the Edit orange button beside the LumiNode ID
- Scan the replacement LumiNode's QR code.
- Tap on Next and Done.
- Once finished, disconnect the LumiSense (Pro) cable from the original LumiNode. Then connect the replacement LumiNode to the same sensor cable.
- Allow time for the LumiNode to obtain network connectivity and send data. Observe the last updated time for the desired job on the LumiCon app to confirm that new data is received